en
Home Connect
38
Energy management
You can connect your appliance to your
smart energy system (Energy manager).
Once you have connected your
appliance to the smart energy system
(Energy manager) and activated the
Flex start
function, you will be able to
optimise your energy consumption
because your appliance will not start up
until your home photovoltaic system can
provide sufficient energy or the energy
tariff is good.
Further information and system
requirements for using the Energy
manager can be found at:
www.home-
connect.com/energymanagement
Notes
■
The smart energy system (Energy
manager) must use the EEBus
initiative communications standard.
■
Before you start, read the smart
energy system instruction manual to
find out how to connect your
appliance to the smart energy
system (Energy manager).
1.
Set the programme to position 7.
“Ÿ®
(Energy manager) appears in
the display.
2.
Press
Start/Reload
‹
.
Your appliance now attempts to
connect to the smart energy system
(energy manager). If the appliance
has connected successfully,
™©Ÿ
appears in the display.
3.
Activate Flexstart if you want the
smart energy system (Energy
manager) to start up your appliance.
Flex start
Activate the
Flex start
function to allow
your smart energy system (Energy
manager) to start your appliance once
your home photovoltaic system is able
to provide sufficient energy or the
energy tariff is good.
Note:
Your smart energy system
(Energy manager) cannot start your
appliance until it is connected to the
appliance.
Activate
Flex start as follows:
1.
Select the programme you require.
2.
Use the
N
and
M
selection buttons
for the "Finished in" time to set the
required time.
3.
Press
Start/Reload
‹
.
4.
Press
Remote Start
}
.
±
appears in the display.
The
FlexStart
function has now been
activated and the appliance will wait to
be remotely started by the smart energy
system (Energy manager).
If the time changes on the display to
„
.
‹œ
, for example, the smart energy
system (Energy manager) has
established a time at which your
appliance can start. The programme will
end after the specified time.
#
+
3
;
