en
Faults and what to do about them.
24
3
Faults and what to do
about them.
Faults and what to do about them.
Information on the display panel
Faults and what to do about them.
Display
Cause/remedy
v
Close the door properly; washing may be trapped.
E:17
Turn on tap fully, inlet hose kinked/jammed; water pressure too low, clean filter
~
Page 23
E:18
Drain pump blocked; clean the drain pump
~
Page 22
Drainage hose/outlet pipe blocked; clean drainage hose on the siphon
~
Page 23
E:23
There is water in the base plate, the appliance is leaking. Call the after-sales ser-
vice.
~
Page 26
w
If child lock is active, deactivate it
~
Page 18
x
~
flashes: Too much foam detected?
~
Page 24
:
~
flashes: Mains voltage too low
~
Page 21
.
~
flashes: Undervoltage during the washing programme. The programme
length is extended.
~
Page 21
Other displays
Switch off the appliance, wait for 5 seconds and switch it back on again. If the
indicator appears again, call the after-sales service
~
Page 26
Faults
Cause/remedy
Water is leaking from the
appliance.
■
Attach the drain hose correctly or replace it.
■
Tighten the threaded joint on the inlet hose.
The appliance is not filling
with water.
Detergent is not being dis-
pensed.
■
Start button not selected?
■
Is the tap turned on?
■
Could the filter be clogged? Clean the filter.
~
Page 23
■
Is the inlet hose kinked or trapped?
The door cannot be
opened.
■
The safety function is activated. Stop the programme?
■
- - - (Rinse stop = without final spin) selected?
~
Page 19
The programme does not
start.
■
Start button or
5
Finished in (Ready in) time selected?
■
Is the door closed?
■
Child lock active? Deactivate.
~
Page 18
The water is not draining.
■
- - - (Rinse stop = without final spin) selected?
~
Page 19
■
Clean the drain pump.
~
Page 22
■
Clean the drain pipe and/or the drain hose.
Water is not visible in the
drum.
Not a fault - the water is below the visible area.
