en
Troubleshooting
46
Fault
Cause and troubleshooting
"E:30 / -80"
Unapproved extension installed on the water drain
hose.
▶
Remove any unapproved extensions from the water
hose. Connecting the appliance
The pump cap is not fully screwed in.
▶
Ensure that the pump cap is screwed in all the way
into the appliance. The handle on the pump cap
must be in a vertical position.
"E:36 / -25 / -26"
Drain pump is blocked.
▶
"Cleaning the drain pump", Page 41
"E:38 / -25 / -26"
Drain pump is blocked.
▶
if the fault is displayed again,
▶
"Cleaning the drain pump", Page 41
Inlet opening of the rubber gasket is blocked.
▶
"Cleaning the intake opening in the rubber gas-
"E:10 / -00 / -10 /
-20"
The pump for the intelligent dosing system is blocked.
1.
Switch off the appliance.
2.
Clean the pump unit.
→
"Cleaning the detergent drawer", Page 40
3.
If this display appears again, call customer service.
→
Note:
You can start the washing programme if you de-
activate the intelligent dosing system and dose manu-
ally.
→
The water pressure is low.
No remedial action possible.
The filter in the water inflow is blocked.
▶
Clean the water inflow filter.
The tap is turned off.
▶
Turn on the tap.
The water inlet hose is kinked or jammed.
▶
Ensure that the water inlet hose is not kinked or
jammed.
"E:35 / -10"
There is water in the base trough.
▶
Turn off the water tap.
▶
Call the after-sales service.
→