Siemens WM6HXEL0DN, Руководство пользователя и инструкции по установке

Страница: 14 / 72

en
Installation and connection
14
5
Connection adapter
Requirements for the installa-
tion location
The appliance may "wander" when it
spins. Observe the instructions for the
installation location.
Note:
Please read the safety informa-
tion → Page 4 to ensure that you use
the appliance safely.
WARNING
Risk of electric shock!
The appliance contains live parts.
Touching live parts is dangerous.
▶
Do not operate the appliance without
a cover cap.
WARNING
Risk of injury!
When using the appliance on a base,
the appliance may tip over.
▶
Always secure the feet of the appli-
ance to a base using the manufac-
turer's fixing brackets →
Page 35
before using the appliance for the
first time.
ATTENTION!
¡
If the appliance is installed in areas
exposed to frost or outdoors, frozen
residual water may damage the ap-
pliance and frozen hoses may crack
or split.
▶
Do not install or operate this appli-
ance anywhere that is liable to ex-
perience frost and/or outdoors.
¡
The appliance underwent a function
test before leaving the factory and
may, therefore, contain residual wa-
ter. This residual water may leak out
if the appliance is tilted at an angle
greater than 40°.
▶
Tilt the appliance carefully.
Installation location Requirements
On a base Secure the appliance
with fixing brackets
→
Page 35 .
On a wooden joist floor Place the appliance on
a water-resistant
wooden board which is
screwed tightly to the
floor. The wooden
board should be at
least 30 mm thick.
In a kitchen unit ¡ A niche width of 60
cm is required.
¡
Only install the ap-
pliance underneath
a continuous work-
top that is securely
connected to adja-
cent cabinets.
On a wall Do not trap the hoses
between the wall and
the appliance.
Removing the transit bolts
The appliance is secured for transport-
ation using transit bolts on the rear of
the appliance.
Notes
¡
Please read the safety information
→
Page 4 to ensure that you use the
appliance safely.
¡
Keep the transit bolts, screws and
sleeves in a safe place for future
transport →
Page 65 .
1.
Pull the hoses out of the holders.