en
Home Connect
46
a
If the appliance has connected to
the energy manager successfully,
the display shows and .
4.
Activate Flex Start if you want the
smart energy system (energy man-
ager) to start up your appliance.
→
"Activate Flex Start", Page 46
Activate Flex Start
Activate Flex Start to allow your smart
energy system (energy manager) to
start your appliance once your home
photovoltaic system is able to
provide sufficient energy or the en-
ergy tariff is good.
Requirement:
The smart energy sys-
tem (energy manager) cannot start
your appliance until it is connected to
the appliance.
1.
Set the programme you require.
2.
Press
- Ready in
+
to set the re-
quired time.
3.
Press
Start/Reload
.
4.
Press
Start/Reload
.
a
The display shows and Flex Start
is activated. The appliance waits to
be started by the smart energy
system (energy manager).
a
If the time changes on the display,
e.g. to 8 h, the smart energy sys-
tem (energy manager) has estab-
lished a time at which your appli-
ance can start.
a
If the smart energy system (energy
manager) does not start the appli-
ance within the set time, the appli-
ance will start the programme itself
before the set time period ends.
The programme ends when the
time period ends.
Note
Flex Start is deactivated for safety
reasons in the following
circumstances:
¡
Press
Start/Reload
.
¡
Open the door.
¡
Switch off the appliance.
¡
Power failure.
16.6 Activating Wi-Fi on the
appliance
Note:
When Wi-Fi is activated, the en-
ergy consumption increases in com-
parison to the values specified in the
consumption value table.
1.
Press and hold
Remote start
for
approx. 3 seconds.
2.
Set the programme to position 4.
a
The display shows
Con
.
3.
Press
Start/Reload
repeatedly
until the display shows
On
.
a
Wi-Fi is activated.
Notes
¡
If Wi-Fi is activated, the appliance
will not switch itself off automatic-
ally.
¡
If Wi-Fi is activated, the appliance
will not switch itself off automatic-
ally.
16.7 Deactivating Wi-Fi on the
appliance
1.
Press and hold
Remote start
for
at least three seconds.
2.
Set the programme to position 4.
a
The display shows
Con
.
3.
Press
Start/Reload
repeatedly
until the display shows
OFF
.
a
Wi-Fi is deactivated.
Note:
If Wi-Fi is switched off and your
appliance was previously connected
to your home network, this connec-
tion will be re-established automatic-
ally when Wi-Fi is switched back on.
16.8 Software update
Requirement:
The display shows
UdP
.
Содержание WM16XKH0ZA
Страница 23: ...Display en 23 Display Designation Description E 35 10 1 Error Error code error display signal 1 Example ...
Страница 74: ......
Страница 75: ......