Siemens WM16XKH0EU, Руководство пользователя

Страница: 37 / 72

Basic operation
en
37
Tip:
In addition to intelligent dosing,
you can also add additional care
product for laundry, e.g. stain remover,
starch or bleach, to the manual dosing
compartment. Do not add any addi-
tional detergent to the manual dosing
compartment to avoid overdosage
and/or foaming.
Requirement:
Find out the optimum
dosage for detergent and care product.
→
Page 34
1.
Pull out the detergent drawer.
2.
Pour in detergent.
→
"Detergent drawer", Page 20
3.
If required, add the care product.
4.
Push in the detergent drawer.
Starting the programme
Note:
If you want to change the time
until the programme ends, set the
"Ready in" time first.
▶
Press
Start / Reload
⁠ .
a
The drum rotates and load detection
takes place. This can take up to 2
minutes, after which water enters the
drum.
a
The display shows either the pro-
gramme duration or the "Ready in"
time.
a
After the programme has ended, the
display shows:
End
.
Soaking laundry
You can soak the laundry before wash-
ing in the appliance by pausing the
programme.
Note:
No additional detergent is re-
quired. The soaking solution is then
used for washing.
1.
Start the programme.
2.
To pause the programme, after ap-
prox. 10 minutes, press
Start / Re-
load
⁠ .
3.
To resume the programme, after the
desired soaking time, press
Start /
Reload
⁠ .
Adding laundry
Note:
Please read the safety informa-
tion → Page 4 to ensure that you use
the appliance safely.
1.
Press
Start / Reload
⁠ .
The appliance is paused and checks
whether it is possible to add or re-
move laundry. Take note of the pro-
gramme status.
→
"Display", Page 21
2.
Add or remove laundry.
3.
Close the door.
4.
Press
Start / Reload
⁠ .
Cancelling the programme
Once the programme has started, you
can cancel it at any time.
Note:
Please read the safety informa-
tion → Page 4 to ensure that you use
the appliance safely.
1.
Press
Start / Reload
⁠ .
2.
Open the door.
The appliance door remains locked
for safety reasons if the temperature
and water levels are high.
– If the temperature is high, start the
Rinse
programme.
– If the water level is high: Start the
⁠
Spin
or
Empty
pro-
gramme.
3.
Remove the laundry.
Resuming the programme
when the programme status
is Rinse Hold
1.
Set the ⁠
Spin
or
Empty
pro-
gramme.
2.
Press
Start / Reload
⁠ .