Siemens WM14VPH9GB, Руководство пользователя и инструкции по установке

Страница: 55 / 64

Troubleshooting
en
55
Fault Cause troubleshooting
Loud noises during the spin
cycle. Appliance is not correctly
aligned.
▶
Aligning the appliance
The appliance feet are not
fixed.
▶
Secure the appliance feet. Aligning
the appliance
Transit bolts have not been
removed.
▶
Removing the transit bolts
Persistent, quiet whirring fan
noise. Active oxygen treatment is
active.
▶
Not a fault – normal operating
noise.
Banging noises, rattling in
the drain pump. Foreign bodies have got into
the drain pump.
▶
→
"Cleaning the drain pump",
Page 45
Slurping, rhythmical suction
noise. The drain pump is active, the
detergent solution is
pumped out.
▶
Not a fault – normal operating
noise.
Problem with results
Fault Cause troubleshooting
Creasing. The spin speed is too high.
▶
The next time you run a wash cycle,
set a lower spin speed.
The load is too large.
▶
The next time you run a wash cycle,
reduce the amount of laundry being
loaded.
The wrong programme is se-
lected for the type of fabric.
▶
Select the programmes that are
suitable for the type of fabric.
→ "Programmes", Page 24
Detergent or fabric softener
drips off the seal and col-
lects on the door or in the
seal fold. Too much detergent/fabric
softener in the detergent
drawer.
▶
When dosing liquid detergent and
fabric softener, observe the mark-
ing in the detergent drawer and do
not dose above this.
The spin result is not satis-
factory. The laundry is too
wet/too damp. A low spin speed is selected.
▶
The next time you run a wash cycle,
set a higher spin speed.
▶
Start the Spin programme.
Less Ironing is activated.
▶
Select the programmes that are
suitable for the type of fabric.
→
"Programmes", Page 24
The unbalanced load detec-
tion system has interrupted
the spin cycle because the
laundry is unevenly distrib-
uted.
▶
Redistribute the laundry in the
drum.