Siemens WM14VKHEDN, Руководство пользователя и инструкции по установке

Страница: 65 / 76

Troubleshooting
en
65
Fault Cause and troubleshooting
The spin result is not
satisfactory. The laun-
dry is too wet/too
damp. A low spin speed is selected.
▶
The next time you run a wash cycle, set a higher
spin speed.
▶
Start the
Spin
programme.
is activated.
▶
Select the programmes that are suitable for the
type of fabric.
→
"Programmes", Page 26
Drain pipe or water outlet hose is blocked.
▶
Clean the drain pipe and the water outlet hose.
Drain pipe or water drain hose is caught or jammed.
▶
Ensure that the drain pipe and water drain hose are
not kinked or trapped.
The unbalanced load detection system has interrupted
the spin cycle because the laundry is unevenly distrib-
uted.
▶
Redistribute the laundry in the drum.
Note:
Where possible, mix large and small items in
the drum. Different sized items of laundry distribute
themselves better during the spin cycle.
▶
Start the
Spin
programme.
Unbalance load detection system is using a reduced
spin speed to eliminate an unbalance.
▶
Redistribute the laundry in the drum.
Note:
Where possible, mix large and small items in
the drum. Different sized items of laundry distribute
themselves better during the spin cycle.
▶
Start the
Spin
programme.
Detergent residue on
the damp washing. Detergents may contain water-insoluble substances
that deposit on the laundry.
▶
Start the
Rinse
programme.
Unsuitable detergent added to the dispenser of the in-
telligent dosing system.
1.
Check whether the detergent used is suitable.
2.
Drain the dispenser.
→
"Cleaning the detergent drawer", Page 50
3.
Clean the dispenser.
4.
Refill the dispenser.
→
"Filling the dispenser", Page 41
Basic dosage is not correctly adjusted.