OPERATION
•
REMOVE ALL DEBRIS FROM THE ITEMS TO BE WASHED BEFORE PLACING THEM INTO THE BASKET.
•
LOAD ITEMS INTO THE BASKET PROVIDED ENSURING NO ITEMS ARE COVERING EACH OTHER
-
PUSH THE BASKET INTO THE MACHINE.
•
CLOSE THE DOOR
-
PRESS THE
CYCLE START SWITCH
-
THE WASHING CYCLE WILL BEGIN AND THE
WASH CYCLE LAMP
WILL COME ON.
•
AT THE END OF THE
CYCLE THE
WASH CYCLE LAMP
WILL GO OUT
-
OPEN THE DOOR AND PULL OUT THE BASKET.
•
ALLOW
EXCESS WATER TO RUN OFF BEFORE REMOVING THE BASKET.
•
CLOSE THE DOOR IF YOU ARE NOT WASHING TO CONSERVE TEMPERATURES .
PREPARATION
•
CHECK THE
DRAIN PLUG
IS
PUSHED
FIRMLY IN PLACE AND
FILTERS
ARE PROPERLY LOCATED.
•
CHECK THE
DETERGENT
CHEMICAL (RED) AND
RINSE AID
CHEMICAL (CLEAR)
SUPPLY TUBES
-
WITH
FOOT VALVES
ATTACHED ARE SUBMERGED IN SUFFICIENT
CHEMICAL. WHEN THE CHEMICAL IN THE CONTAINER IS LOW REPLACE WITH A FULL CONTAINER. DO NOT USE THE MACHINE IF THERE IS NO CHEMICAL.
•
CHECK THE DOOR IS CLOSED AND PRESS THE
POWER
SWITCH
-
THE GREEN
POWER LAMP
WILL COME ON.
•
WAIT FOR THE MACHINE TO FILL WITH WATER AND REACH THE CORRECT WASHING TEMPERATURE. THE
MACHINE READY LAMP
WILL COME ON.
(OPTIONAL DRAIN PUMP)
REMOVE DRAIN PLUG THEN
SWITCH THE MACHINE OFF
TO START THE AUTOMATIC
DRAIN PUMP CYCLE
POWER
LAMP
WASH CYCLE
LAMP
MACHINE
READY
LAMP
POWER
SWITCH
CYCLE START
SWITCH
(SXD MODELS ONLY)
CYCLE TIME SWITCH
2` 3` MINUTE
ED50 / SD45 / SXD45 / SD50 / SXD50 A + IS + D
USER GUIDE
(SXD MODELS ONLY)
CYCLE TIME
SELECTION LAMP
(SOFTENER MODELS)
REGENERATION LAMP
(SOFTENER MODELS)
SALT LOW LAMP
WATER SOFTENER REGENERATION MODELS
•
THE
SALT LOW LAMP
WHEN ON WARNS IF THE SALT CONTAINER IS LOW ON SALT OR EMPTY.
•
UNSCREW THE
SALT CONTAINER LID
LOCATED INSIDE THE WASH TANK AND FILL WITH GRANULAR CATERING SALT ( THE SALT CONTAINER WILL REGENERATE
APPROXIMATELY FIVE REGENERATION CYCLES & HOLDS 500g OF SALT).DO NOT OVERSPILL, IF SALT IS SPILT ONTO STAINLESS STEEL RINSE THOROUGHLY WITH
WATER. ENSURE THE
SALT CONTAINER LID
IS SECURE AFTER FILLING.
•
THE WATER SOFTENER REGENERATION CYCLE WILL BE FULLY AUTOMATIC AND WHEN REQUIRED STARTS AFTER THE FIRST FILL AND DURING THE INITIAL
HEATING OF THE MACHINE.
•
THE REGENERATION LAMP WILL BE ON WHILE THE MACHINE CLEANS AND REGENERATES THE SOFTENER SYSTEM.
•
THE MACHINE WASH CYCLE START IS DISABELED DURING THE 15 MINUTE REGENERATION. DO NOT SWITCH OFF THE MACHINE WHILE REGENERATING.
•
WHEN REGENERATION IS COMPLETE THE
WATER SOFTENER REGENERATION LAMP
WILL GO OUT AND THE MACHINE WILL CONTINUE TO HEAT.
•
WAIT FOR THE MACHINE TO REACH THE CORRECT WASHING TEMPERATURE. THE
MACHINE READY LAMP
WILL COME ON.
•
THE MACHINE IS NOW READY TO START WASHING.
FOOT VALVE AND FILTER FOR
THE CHEMICAL TUBES
www.dcproducts.co.uk
DC Products
DRAIN PLUG
FILTER
LOWER SUMP
SALT CONTAINER
WASH ARM
RINSE ARM
RINSE ARM RETAINING NUT
SALT
SALT CONTAINER LID
RINSE PIN
