Siemens WM14VK0CFG, Руководство пользователя и инструкции по установке

Страница: 58 / 72

NL Troubleshooting
Malfunction
Cause and Troubleshooting
The program duration
changes during the
wash cycle.
The foam control system provides an extra rinse if
the foam is too high.
▶
No error - no action required.
The water is not
visible in the drum
bar.
The water is below visible range.
▶
No error - no action required.
▶
Do not fill any additional water into the appliance during operation.
honeycomb.
Drum jerks after
program start.
The cause is an internal motor test.
▶
No error - no action required.
Vibration and movement The appliance is not leveled properly.
of the appliance
during the spin
run.
▶
Adjusting the device
Device feet are not fixed.
▶
Secure the device feet. Setting the appli-
raat
Transport protections have not been removed.
▶
Remove transport locks
Drum is spinning, er
Load recognition is active.
▶
No error, no action necessary.
no water flowing in
the device.
Remark: The load detection can take up to 2 minutes.
strong foam
ming.
Detergent dosage is too high.
▶
Immediate measure: mix a tablespoon of fabric softener
ter with 0.5 l of water and pour this mixture into
the manual dosing compartment (not for outdoor,
sportswear and down textiles).
▶
When the intelligent dosing is activated, re-
then induce the basic dosing amount
→ Page 42.
▶
When dosing manually, reduce to the full
next wash with the same load the amount of
detergent.
can't be
pressed
Intelligent dosing is not possible for this program.
▶
No error - no action required.
Program progress does not allow intelligent dosing.
No solution possible.
High spin speed
rental is not
reached.
Low spin speed is set.
▶
For the next wash, set a higher spin
speed in.
Anti wrinkle is activated.
58