Sensors
en
21
Programme end
End
appears on the display panel and
the Start/Reload button indicator lamp
is off.
If the
x
symbol appears on the display
panel, the washing machine has
detected too much foam during the
wash programme and automatically
switched on a rinse cycle to remove the
foam.
Note:
Add less detergent for the next
washing cycle with the same load.
Removing laundry/switching
off the appliance
1.
Open the washing machine door
and remove the laundry.
2.
Set the programme selector to
Off
.
The appliance is switched off.
3.
Turn off the water tap.
Note:
Not required for Aqua-Stop
models.
Notes
■
Do not leave any items of laundry in
the drum. They may shrink in the
next wash or discolour another item.
■
Remove any foreign objects from the
drum and the rubber seal – risk of
rusting.
■
Leave the washing machine door
and detergent drawer open so that
any residual water can dry away.
■
Always wait for the end of the
programme, otherwise the appliance
may still be locked. Then switch on
the appliance and wait for it to
unlock.
■
If the display panel goes off at the
end of a programme, energy-saving
mode is active. To activate the panel,
press any button.
H
Sensors
Sen
sor
s
Automatic load sensing
The automatic load sensing function
adapts the water consumption ideally to
each programme depending on the
type of fabric and the load.
Unbalanced load detection
system
The automatic unbalanced load
detection system detects imbalances
and ensures even distribution of the
laundry by repeatedly starting and
stopping drum spinning.
If the laundry is extremely unevenly
distributed, the speed is reduced or the
spin cycle is not performed for safety
reasons.
Note:
Place large and small items of
laundry evenly in the drum.
~
Page 26
