Siemens WM T Series, Инструкция по эксплуатации и руководство по установке

Страница: 48 / 54

en
Faults and what to do about them.
48
k
is flashing Run the O чи c тка барабана (Drum Clean) 90 °C program or a 60 °C program to
clean and care for the drum and the outer tub.
Notes
■
Run the program without laundry.
■
Use all-purpose washing powder or a detergent that contains a bleaching
agent. To prevent foaming, only use half the amount of detergent recom-
mended by the detergent manufacturer. Do not use detergents intended for
woollens or delicates.
■
Switch the notification signal on/off
o
is continuously lit Too much foam has been detected; additional rinse cycles have been activated.
Ó
is continuously lit Only for programs with automatic dosing activated:
■
The detergent drawer has not been pushed in fully. Push the detergent drawer
in fully.
■
The pump unit is not inserted. Insert the pump unit into the drawer lid.
¨
or
M
is flashing There is not enough detergent/softener in the
¨
or
M
dispenser. Pour more
detergent/softener into the relevant dispenser.
~
Page 39
E:10 alternating with
- 00, - 10 or - 20
The pump unit of the automatic dosing system is blocked. Switch off the appliance.
Clean the pump unit.
~
Page 41
If this indicator/symbol/code appears again, call our after-sales service.
E:60 alternating with
- 2b and End
at the end of the program.
Not an appliance fault – the unbalanced load detection system has interrupted the
spin cycle because the laundry is unevenly distributed.
Distribute small and large items of laundry evenly in the drum. Run the spin cycle
again, if necessary.
E:35 alternating with
- 10
There is water in the base trough; the appliance is leaking. Turn off the tap. Call the
after-sales service.
~
Page 52
E:36 alternating with
- 10
■
The drain pump is blocked. Clean the drain pump.
~
Page 45
■
The drain hose/drain pipe is blocked. Clean the drain hose at the siphon.
~
Page 46
I am unable to con-
nect to my home net-
work.
■
Wi-Fi is switched off.To connect to your home network, switch on Wi-Fi.
|
must appear on the display.
■
Wi-Fi is switched on but a connection to your home network cannot be estab-
lished.Check whether your home network is available or try to connect to your
home network again.
Other indicators/sym-
bols/codes
Switch off the appliance, wait for 5 seconds and then switch it back on. If this indica-
tor/symbol/code appears again, call our after-sales service.
~
Page 52
Indicator/symbol Cause/remedy