a
3
Removing transport bolts
– Before using the appliance for the first time, always remove and retain
all 4 transport bolts.
– If transporting the appliance subsequently, always re-install the
transport bolts - this prevents damage to the machine
a
page 6.
– Retain the screw and spacer.
1.
Take the hoses (depending on the model) out of the holder and the elbow.
Remove the elbow.
2.
Undo and remove all 4 transport bolts.
3.
Take the power cord out of the holders. Remove the sleeves.
4.
Insert the covers and lock them in place by pressing on the locking hook. Insert the hose
holders.
5.
Fix the hoses in the hose holders.
The hose holder in this position is
longer than the others. Please
ensure that the right part is used.
4
Water connection
depending on model
– Risk of electric shock! Do not immerse the Aqua-Stop safety device in water (contains an
electric valve).
– To prevent leakage or water damage, follow the instructions in this chapter.
–
Attention
: operate the washing machine with cold drinking water only.
Do not connect to the mixer tap of a pressureless hot-water heater.
– Do not use a used inlet hose. Only use the inlet hose supplied or one which was
purchased from an authorised specialist dealer.
– If in doubt, have the appliance connected by a technician.
Water supply
Water inlet hose:
–
Attention:
do not kink, crush, modify or cut through
(strength is no longer guaranteed).
Optimum water pressure in the mains: 100-1000 kPa (1-10 bar)
– When the tap is turned on, the water flow is at least 8 l/min.
– If the water pressure is higher, install a pressure reducing valve.
Model:
Aqua-Stop
Aqua-Secure
Standard
1.
Connect the water supply hose to the tap.
Tighten plastic screw fittings by hand only.
2.
Carefully turn on the tap and check that the connection
points are not leaking.
Attention:
the screw connection is under water mains
pressure.
Water drainage
Water drainage hose:
Attention
:
do not kink or stretch.
Height difference between installation area and outlet:
0- 100 cm
Drainage into a sink/bath tub:
Attention:
secure the drainage hose to prevent it from slipping out of
the sink.
Attention:
the plug must not be in the plug hole. When the water is being
pumped out of the washing machine, check that the water drains away
quickly enough. Do not immerse the end of the drainage hose in the water
that has been pumped out. There is a risk that water will be drawn back
into the washing machine.
Drainage into a siphon:
Attention
:
secure the connection with a 24-40 mm dia. hose clip
(available from a specialist retailer).
.
Drainage into a plastic pipe with rubber sleeve:
Attention:
Secure the drainage hose to prevent it from slipping out of
the drain.
min 10 mm
max.
90°
3/4 ’’
max.
90°
3/4 ’’
min 10 mm
