Faults and what to do about them
en
51
The programme has
started and the drum is
rotating, but the drum is
not filling with water.
Not a fault – Some programme specifically detect and weigh the load after the
program has started in order to calculate the optimum amount of water for
washing. The drum will then start filling with water.
The water is not draining.
■
Drain pipe or water drain hose is blocked. Clean the drain pipe and the
water drain hose.
■
Drain pipe or water drain hose is caught or jammed. Ensure that the drain
pipe and the water drain hose are not kinked or trapped.
■
The drain pump is blocked.
"Drain pump is blocked" on page 46
■
The drain hose at the siphon is blocked.
"The drain hose at the siphon is blocked" on page 47
■
- - - is activated (depending on the module). Continue the programme by
selecting
S
ı
kma (Spin)
or
Bo
ş
altma (Drain)
and pressing
I
■
The water drain hose is connected too high. Install the water drain hose at
a maximum height of 1 meter.
"Hose and cable lengths" on page 16
Water is not visible in the
drum.
Not a fault – the water is below the visible area.
The spin result is not sat-
isfactory.
Laundry wet/too damp.
■
Not a fault – the unbalanced load detection system has interrupted the
spin cycle because the laundry is unevenly distributed. Distribute small and
large items of laundry evenly in the drum.
■
Is
Ý
(Easy iron)
additional programme setting selected (depending on
the model)?
■
Is
ç
(Silent)
additional programme setting or
Silent
programme selected
(depending on the model)?
■
Is the selected spin speed too low?
The spin cycle runs sev-
eral times.
Not a fault – the unbalanced load detection system is adjusting an imbalance.
Residual water in the dis-
penser for care product.
■
Not a fault – effect of the care product not impaired.
■
If required, remove the insert. Clean the detergent drawer and re-insert it.
Compartment
M
is not
rinsed out completely.
Remove the insert. Clean the detergent drawer and reinsert it.
The programme is taking
longer than usual.
■
Not a fault – the unbalanced load detection system is adjusting an imbal-
ance by repeatedly distributing the laundry.
■
Not a fault – the foam detection system is activated – a rinse cycle has
been switched on.
The length of the pro-
gramme changes during
the wash/dry cycle.
Not a fault – the programme sequence is optimised for the specific washing/
drying process. This may change the length of the programme shown on the
Touch-Display.
Faults
Cause/Remedy
