Siemens Symaro AQS2100, Руководство пользователя

Страница: 4 / 18

4
Siemens A6V11893002_en--_c
Smart Infrastructure 2021-07-05
The sensor has two sets of DIP switches: S1 and S2.
The different DIP switch positions mean the following:
Test mode V/I output
PM2.5/PM10
range
selection
Output
parameter
selection
Temperature
range selection
Work
mode
Function
1 2 3 4 5 6 7 8
‒ OFF OFF ‒ ‒ ‒ ‒ ‒ DC 0…10 V
(default)
‒ OFF ON ‒ ‒ ‒ ‒ ‒ DC 0…5 V
‒ ON OFF ‒ ‒ ‒ ‒ ‒ 4…20 mA
‒ ON ON ‒ ‒ ‒ ‒ ‒ Back to default
‒ ‒ ‒ OFF OFF ‒ ‒ ‒
0…500 μg/m3
(default)
‒ ‒ ‒ OFF ON ‒ ‒ ‒ 0…300 μg/m 3
‒ ‒ ‒ ON OFF ‒ ‒ ‒ 0…100 μg/m
3
‒ ‒ ‒ ON ON ‒ ‒ ‒ 0…50 μg/m
3
‒ ‒ ‒ ‒ ‒ OFF ‒ ‒ PM2.5 + r.h. +
temperature
(default) 2)
‒ ‒ ‒ ‒ ‒ ON ‒ ‒ PM2.5 + PM10 +
temperature
2)
‒ ‒ ‒ ‒ ‒ ‒ OFF ‒ 0…50 °C (default)
2)
‒ ‒ ‒ ‒ ‒ ‒ ON ‒ - 35…35 °C 2)
‒ ‒ ‒ ‒ ‒ ‒ ‒ OFF
Continuous work
mode (default)
‒ ‒ ‒ ‒ ‒ ‒ ‒ ON Smart work mode
ON ‒ ‒ ‒ ‒ OFF OFF ‒ Test MODE 1
1)
ON ‒ ‒ ‒ ‒ OFF ON ‒ Test MODE 2
1)
ON ‒ ‒ ‒ ‒ ON OFF ‒ Test MODE 3 1)
ON ‒ ‒ ‒ ‒ ON ON ‒ Test MODE 4 1)
Note:
1) For detailed information on the test mode, see
Activating test function [
▶
5]
.
2) These functions are only for QSM2162.
Use the test function to check whether the sensor value inaccuracy is caused by the analog
output error. Users can configure DIP1, DIP6 and DIP7 to check if the actual signal output of
terminals (X1, X2, X3) corresponds to the values defined in
Test function active [
▶
5]
table.
Test function of X3 is valid only for QSM2162.
Activating test
function
DIP switch config-
uration
S1