Siemens SINUMERIK 828D Turning, Руководство по эксплуатации функций

Страница: 1499 / 1799

W1: Tool offset
18.6 Toolholder with orientation capability
Basic Functions
Function Manual, 09/2011, 6FC5397-0BP40-2BA0
1499
Orientation in Z direction
The G function
TOFRAME
defines a frame such that the Z direction in this frame is the same as the current tool
orientation.
If no tool carrier or a tool carrier without change in orientation is active, then the Z direction is in the new frame:
• The same as the old Z direction with
G17
• The same as the old Y direction with
G18
• The same as the old X direction with
G19
.
TCOABS for active frame
The absolute toolholder orientation is set using:
TCOABS
(Tool Carrier Orientation ABSolute)
The orientation taken into account for the tool length compensation is independent of the orientation of the active
frame.
Only one of the instructions
TCOABS
or
TCOFR
can be valid.
Frame change
The user can change the frame following selection of the tool. This does not have any effect on the tool length
compensation components.
Angles in the toolholder data:
The programmed angles of rotation stored in the toolholder data are not affected by the angle of rotation defined
by the frames. When changing from
TCOFR
to
TCOABS
, the original (programmed) angles of rotation in the
toolholder data are reactivated.
Tool compensation types
TRC takes account of the current tool orientation when
CUT2D
or
CUT3DFS
is active.
All other tool compensation types
These are all the compensation types of G-code group 22, with the exception of
CUT3DC
and
CUT3DF
. The
response remains the same with respect to the plane used for compensation. This is determined independent of
the tool orientation from the active frame.
For
CUT2DF
and
CUT3DFF
, the compensation plane used for TRC is determined from the frame independently of
the current tool orientation. The active plane (
G17
/
G18
/
G19
) is considered.
CUT3DC and CUT3DF
3D tool compensation for circumferential milling
3D tool compensations for face milling with active 5-axis transformation are not affected by the "Toolholder with
orientation capability" function.
The orientation information is determined by the active kinematic 5-axis transformation.