7.1.8
Setpoint values for monitoring the bearing temperature
Prior to commissioning
If the machine is equipped with bearing thermometers, set the temperature value for
disconnection on the monitoring equipment before the first machine run.
Table 7-1
Set values for monitoring the bearing temperatures before commissioning
Set value
Temperature
Alarm
115 °C
Shutting down
120 °C
Normal operation
Determine the maximum operating temperature of the bearings T
operation
taking into account the
temperature, bearing load and influences of the plant on the motor in °C. Set the values for
shutdown and warning corresponding to the operating temperature T
op
.
Table 7-2
Set values for monitoring the bearing temperatures
Set value
Temperature
Alarm
T
operation
+ 5 K ≤ 115 °C
Shutting down
T
operation
+ 10 K ≤ 120 °C
7.2
Switching on
Measures for start-up
After installation or inspections, the following measures are recommended for normal start-up
of the machines:
• Start the machine without a load. To do this, close the circuit breaker and do not switch the
machine off prematurely. Switching the machine off again while it is starting up and still
running at slow speed should be kept to a bare minimum, for example for checking the
direction of rotation or for checking in general. Allow the machine to run to a standstill before
switching it back on again.
• Check mechanical operation for noise or vibration at the bearings or end shields.
• If the machine is not running smoothly or is emitting abnormal noises, switch it off, and
determine the cause of the fault as it runs down.
Commissioning
7.2 Switching on
1FZ shaft height 280
82
Operating Instructions, 02/2022, A5E51698698A
Содержание SIMOTICS DP
