PDT IFP Monitor Standard
12
Operating Manual, 10/2017, A5E41104536-AB
IPC Configuration Center
2
2.1
Product description
Along with the PDT software, various software components are installed on your PC
depending on the device features, allowing you to configure the SIMATIC IPC or connected
SIMATIC Industrial Flat Panel. The IPC Configuration Center provides a convenient interface
for operating these software components.
You can use the Configuration Center to configure your device directly or open the
respective setting dialogs of the operating system.
2.2
Overview and tabs
Requirement
●
A corresponding software component is installed for each SIMATIC device type on the
PC (see initial commissioning):
–
for SIMATIC Monitor Standard: SIMATIC IFP Monitor software
–
for SIMATIC IPC/IFP with resistive single-touch screen:
SIMATIC Single-touch software
–
for SIMATIC IPC/IFP with capacitive multi-touch screen:
SIMATIC Multi-touch software
–
for SIMATIC IPC/IFP Touch/Key with resistive single-touch screen:
SIMATIC PhoneKeyPad software
–
for SIMATIC IFP ETH: SIMATIC Ethernet Monitor software
●
The system requirements (Page 6) are met.
