Siemens Simatic S7-300, Инструкция по установке и эксплуатации

Страница: 345 / 356

Fail-safe signal modules
Installation and Operating Manual, 01/2010, A5E00085586-10
345
Index
1
1oo2 evaluation, 32
A
Accessories, 319
Actuator
Additional requirements, 49
Requirements, 47
Address
PROFIsafe, 34, 38
Address assignment
SM 326, DI 24 x DC 24V, 77
Address assignment in standard and safety mode, 31
Address assignment of user data, 31
Address space
Permissible, 33
Address switch, 35
For PROFIsafe addresses, 38
Setting, 36, 39
Addressing
Of the channels in standard mode, 33
SM 336
Diagnostic messages,
Analog value representation of SM 336
Measured value range,
Analog input module SM 336 AI 6 x 13Bit
Measured value resolution, 183
Analog value representation
Measured value range, 299
Approval
FM, 60
UL, 59
Approvals, 4
Assigning parameters, 27
Availability
depending on the F-I/O used, 22
Enhanced, 26
B
Basic knowledge
Required, 3
C
Cable guide, 105, 109
Capacitive loads
Switching, 327
Categories 3 and 4, 16
Category, 22
Causes of the problem
at SM 326, DI 24 x DC 24V, 100
at SM 326, DO 8 x DC 24V/2A PM, 135
for SM 326, DI 8 x NAMUR, 122
SM 336, AI 6 x 13Bit, 216
with SM 326, DO 10 x DC 24V/2A, 153
with SM 326, F-DO 10 x DC 24V/2A PP, 175
CE approval, 4
CE mark, 59
Central configuration, 19
Changes
compared to the previous version, 3
Changes in the manual, 3
Checks
HART reply, 292
CiR, 26, 77
Client, 289
Transfer area,
Commands
HART, 280
Commissioning
of fail-safe signal modules, 17
Configuration
Central, 19
Distributed, 19
Redundant, 41
Configuration in RUN, 77
Configuration in RUN (CiR), 26
Configuration variant
Depending on availability, 22
In safety mode, 21
In standard mode, 20
Configuring, 26
Conventions
applied to this manual, 7
CPU
Approved, 20, 21
Cross circuit
Prevention, 132