Siemens SIMATIC NET CP 1243-1 DNP3, Руководство по настройке

Страница: 91 / 192

Configuration
3.19 Telecontrol connections
Configuration - DNP3
Configuration Manual, 11/2018, C79000-G8976-C508-01
91
3. Click the "Endpoint" field in the same row.
Select the endpoint (CPU) from the table with a double-click.
–
Special case: "Third-party device":
If you want to create a third-party device as endpoint instead of an endpoint from a
STEP 7 project, leave the default entry "Third-party device" in the cell.
Configure the interface of the starting point as well as the address data and other
parameters of the third-party device by means of entries in the corresponding fields.
With a third-party device as endpoint, the connection search via the dialog described
below is disabled.
After an endpoint is selected from the STEP 7 project, the starting point and endpoint are
displayed in the table row. The other fields are usually empty and have a red background.
Once a connection has been created, the actual course of the connection is not always
defined yet. Especially with larger networks, several connection paths are often possible.
To facilitate searching the connection path, the search function is available via the "Add
new connection path" icon:
4. Leave the table row with the selected starting point and endpoint highlighted and click on
the "Add new connection path" icon.
The dialog for defining connection paths opens:
Dialog "Add connection paths"
The possible connection paths are searched for automatically, which is indicated by the
progress bar at the bottom of the dialog.
–
The status and result of the search are displayed in the "Information" field below.
– The connection paths found are displayed in the "Select a connection path ..." upper
table.
– Details for a selected connection path are shown in the "Connection path" table.
– When selecting a connection path, the "Preview" table shows which connection points
of the selected connection path are transferred to the connection editor when you click
"Add".
5. Select the desired connection path(s).
–
If one or more connection paths are displayed in the upper table, select the desired
connection path and click on "Add".
"Information" shows whether the connection path has been added or whether it has
already been configured.
– If you want to use a redundant connection, select a second path and click on "Add".
Close the dialog using the "Close" button if the added connection paths correspond to
the project defaults.
– If no connection is displayed in the table, there is a configuration error in the
corresponding stations or networks.
In this case, close the dialog with the "Close" button and complete the configuration.