Operator controls and displays
5.3 Labeling keys
KP8, KP8F
56
Operating Instructions, 10/2010, A5E03284305-01
"Technical Support
Observe the information in this file.
The labeling strips have the following dimensions:
5
9LVLEOHZLQGRZUDQJH[
$OOGLPHQVLRQVLQPP
Procedure
1.
Edit the template.
2.
Print the template.
You can use printable labels and paper. Always ensure an adequate material stiffness
during the selection. This is needed to insert the labeling strips. The maximum permitted
thickness of the labeling strip is 0.15 mm.
Alternatively, you can also label the strips by hand.
Note
Wait for the printed labeling strips to dry before you insert them.
3.
If you print the labeling strips on foil or paper, cut out the labeling strips.
Ensure that the corners are cut according to the corresponding diagram, as this makes it
easier to slide them into the slot.
4.
Remove any previously existing labeling strips.
5.
Slide the new labeling strips into the guide up to the stop.
The labeling strip will protrude approximately 1 cm out of the guide. The template
dimensions for the labeling strips are designed so that the labeling is correctly placed for
the keys. An interlock is not required for the labeling strips.
