6DL2804-
xxKxx
xxTxx
xxUxx
Material
Stainless steel: DIN 1.4301,
plate thickness: 1.5 mm with edge length up to 800 mm, 2.0 mm with edge length 1 000 mm
or more
Weight [kg]
65
92
100
Cover seal
Silicone rubber
Cable entries
Made of plastic or metal; size and number depending on requirements
Equipotential bonding rail
3 x 10 mm galvanized Cu with terminals 4 to 35 mm²
Protective conductor con‐
nector
M8 screw, at least 16 mm² with cable lug
Rated voltage/current
2)
Max. 1 000 V / 100 A
Operating temperature
range
3)
-20 °C to +xx °C or -40 °C to +xx °C
4)
or 0 °C to xx °C
Permissible humidity
Max. 95%
1)
The degree of protection of the enclosure depends on that of the installed parts and the enclosure size.
2)
The actual electrical values depend on the electrical equipment installed. The manufacturer specifies the final values within
the framework of these limits.
3)
The specified permissible operating temperature range is only valid if the enclosure is installed horizontally. A vertical
installation can reduce the maximum permissible temperature (for information on this refer also to the ET200iSP manual).
The max. operating temperature is defined depending on the dissipated heat of the installed components, and specified
on the nameplate.
Note that the operating temperature of the complete setup must be checked again if further components are subsequently
fitted.
4)
The temperature range of -40 °C only applies to the enclosure types 6DL2804-1xxx1 (metal cable entries). Installation of
a heater is required for this.
Ex marking
II 2 (1) G Ex e d ib [ia Ga] IIC T4 Gb (with heater T3) or
II 2 (1) G Ex e d mb ib [ia Ga] [ia op is Ga] IIC T4 Gb (with heater T3) or
II 2 (1) D Ex tb [ia IIIC Da] IIIC T130°C Db or
II 2 (1) D Ex tb [ia IIIC Da] [Ex ia Da] IIIC T130°C Db
I M2 Ex e d ib [ia Ga] I Mb or
I M2 Ex e d mb ib [ia Ga] I Mb
Technical specifications
Distributed I/O device 6DL2804-1xxxx & 6DL2804-2xxxx
Hardware Installation Manual, 07/2017, A5E42025214-AA
31