Siemens SCD 19101 D, Руководство по эксплуатации

Страница: 37 / 55

Instruction manual 09.08
5 Connections
5.1 Connecting the flat panel display
Note
All screening precautions contained in the corresponding EMC guidelines must be
observed. If these guidelines are not observed, interference signals could
penetrate the monitor.
Information on cable installation
•
Only shielded cables are permitted for all signal connections.
•
All connectors should be of screw or locking types (as far as possible).
•
Signal and power cables must not be routed in the same duct.
•
The display must not share a power supply with motors or valves (glitches!).
5.2 Connection panel
A connection panel for the signals and power supply is located at the rear of the
flat panel display underneath a cover.
Connection panel of the color flat panel display SCD 19101 D/DT
The USB-cable for the touch screen is connected beneath the RS 232 interface.
5.2.1 Power supply connection
Note
Device fuses must only be replaced by the servicing department.
The display power supply is connected using an appliance plug.
Only use the power cable supplied in the delivery, or a cable with PE conductor
and appliance socket to DIN 49547, IEC 320.
Caution
A power cable with PE conductor must be used which corresponds to the safety
requirements of the respective country of use.
36
Hochauflösendes 19“ Color Flat Panel Display SCD 19101 D/DT
A5E00316182-003