Siemens SCD 19101 D, Руководство по эксплуатации

Страница: 35 / 55

Instruction manual 09.08
•
Service connection: This is an RS 232 interface reserved for servicing (updating
of firmware such as special wishes). Access is exclusively via the authorized
servicing departments.
Following connection of all cables, the covers (rear panel and base) must be
correctly replaced.
4.2 Switching on the device
•
Switch on the device using the OSD key "down, on/off".
The green operation LED now lights up permanently (if the video signal is not
connected, the green operation LED flashes rapidly).
Status of operation LED
Operation LED 110 ... 230 V Monitor <-> Video signal
OFF NO – –
Flashes slowly YES OFF –
Flashes rapidly YES ON NO
ON YES ON YES
4.3 Adjusting the image geometry
The display automatically recognizes the used standard, and set-up values for
each standard are preprogrammed. However, depending on the graphics card
used, it may still be necessary to align and size the picture for the selected
standard (see Section 6.1 "Picture adjustment").
4.4 Adjusting the brightness and contrast
The brightness and contrast must be adjusted for the respective graphics card
(different output levels) in the system on site.
34
Hochauflösendes 19“ Color Flat Panel Display SCD 19101 D/DT
A5E00316182-003