4
Siemens Building Technologies
Fire Safety & Security Products
01.2009
Ø 6 mm
S6
4,5 x 45
1,5 cm
A
A
B
C
D
Fig. 3
Mount the housing
1.
Mark the drilling position for the four external mounting
holes (A) Fig. 3.
2.
Drill holes and insert plugs.
3.
Screw in the screws leaving approximately 1.5 cm
proud (B) Fig. 3.
4.
Snap the spacers in at the four mounting holes from
the back in the intended slots (Fig. 3).
5.
Route the connection cable through the cut-outs (D) in
the back wall and hang the back on the screws .
6.
Tighten the screws.
Fig. 4
Mount boards (option)
1.
Snap the fastening supports (included with the board)
into the intended holes (A) Fig. 4.
2.
Fit circuit boards (B) Fig. 4.
Wiring
The terminals can be seen in Fig. 2 or in the wiring
diagram on the inside of the housing cover.
