Siemens RUGGEDCOM RS950G, Руководство по установке

Страница: 19 / 42

RUGGEDCOM RS950G
Installation Guide
Chapter 2
Installing the Device
Mounting the Device to a Panel 9
Section 2.1.2
Mounting the Device to a Panel
For panel installations, the RUGGEDCOM RS950G can be ordered with mounting brackets that mount to the top
and bottom of the chassis.
To mount the device to a panel, do the following:
1. Remove the bracket mounting screws from the top and bottom of the chassis.
2. Install the mounting brackets to the top and bottom of the chassis using the bracket mounting screws. Make
sure the screws are hand-tightened.
3. Place the device against the panel and align the mounting brackets with the mounting holes.
3 12 11
Figure 5: Panel Mounting
1. Bracket Mounting Screw 2. #6 Screw 3. Mounting Bracket
4. Using #6 screws of sufficient length (not provided), secure the mounting brackets to the panel. Use wall
anchors (not provided) where required.
Section 2.2
Connecting the Failsafe Alarm Relay
The failsafe relay can be configured to latch based on alarm conditions. The NO (Normally Open) contact is closed
when the unit is powered and there are no active alarms. If the device is not powered or if an active alarm is
configured, the relay opens the NO contact and closes the NC (Normally Closed) contact.