Low Temperature Detection Cut-out and Alarm Thermostat
Technical Instructions
Document Number 155-016P25
Rev. 1, February, 2000
Siemens Building Technologies, Inc.
Page 5
Figure 2. Bulb Mounting for Limited Access Ducts with 808-412 Mounting Flange.
Wiring
WARNING:
Disconnect the power supply before wiring connections are made to
avoid possible electrical shock or damage to the equipment.
Make all wiring connections using copper conductors only and in accordance with the
National Electrical Code and local regulations. Loads exceeding the rating of the
thermostat should be handled by means of a relay or motor starter.
An opening for 1/2-inch conduit is provided in the bottom of the thermostat enclosure.
See
Figure 3
for a typical wiring diagram.
Figure 3. Typical Wiring Diagram.
CAUTION:
Use terminal screws furnished (#8-32 x 1/4-inch binder head screw).
Longer terminal screws can interfere with switch mechanism and
damage the switch.
