GAMMA
instabus
Technical product information
December 2009
N 562/11
Switching actuator, main module
5WG1
562-1AB11
3x AC 230/400 V, 10 AX, C-load, load-check
Technical manual
N 562/11, 6 pages
Siemens AG
Industry Sector, Building Technologies
Update: http://www.siemens.com/gamma
© Siemens AG 2009
Low Voltage Distribution
Subject to change without further notice
P.O. Box 100953, D-93009 Regensburg
2.4.3.4/4
Location and function of the display and
operating elements
A1
A4
A10
A11
A9
A8
A12
A6
A7
A5
A3
A2
Figure 2. Display and operating elements
A1
Plug for bus connection terminal block
A2
Pushbutton for switching between normal / address-
ing mode for transferring the physical address.
A3
LED for indicating normal mode (LED Off) or address-
ing mode (LED On); it turns off automatically after
transferring the physical address
A4
Jack for connection of a switching actuator sub-
module
A5
LED to indicate the selected device
A6
Pushbutton to toggle between Bus / Direct mode
A7
LED to indicate Direct mode = On
A8
Pushbutton for direct operation of outputs 1...3
A9
LED to indicate whether the corresponding output is
switched on or off.
A10
Without function
A11
Without function
A12
Screw-type terminals of outputs 1...3
Installation and wiring
Mounting / dismounting the device:
see figure 3 and 4
Figure 3. Mounting the device
Figure 4. Dismounting the device
Connecting / disconnecting the bus cable: see figure 5
D2
D2.4
D2
D2.4
5 mm
D2.1 D2.2
2
D2.3
D
Figure 5. Connecting / disconnecting the bus cable
Connecting a switching actuator submodule: see figure 6
Snap the switching actuator submodule on to the rail
and push it to the left against the switching actuator
main module or against the switching actuator sub-
module. Connect both devices using the bridging con-
nector supplied.
A
B
C
Figure 6. Connecting a switching actuator submodule
B1
B2
C3
C1
C2
