Operating the appliance
en
7
powerBoost position
On some appliances, the glass front can be adjusted to
an intermediate position (powerBoost position). The
powerBoost position can be used for eliminating
particularly strong cooking smells and large amounts of
steam.
Take hold of the glass front in the centre and open it
carefully.
Automatic mode
Switching on
■
Touch the
#
symbol.
The fan will start at setting 2.
■
Touch the
!
symbol.
The optimum fan setting is set automatically using
an air quality sensor.
Switching off
Touch the
!
or
#
symbol to switch off automatic
mode.
The fan will switch itself off automatically if the air quality
sensor detects no further change in the air quality in the
room.
Automatic mode can run for a maximum of four hours.
Sensor control
In automatic mode, an air quality sensor in the extractor
hood detects the intensity of the cooking and roasting
odours. Depending on the air quality sensor setting, the
fan will switch itself to another fan setting automatically.
Possible sensor settings:
Default sensitivity setting:
„
Lowest sensitivity setting:
‚
Highest sensitivity setting:
†
If the sensor controller responds too strongly or not
enough, it can be changed accordingly:
1.
Touch and hold the
!
symbol for one second
when the fan is switched off. The setting will be
displayed.
2.
Slide your finger across control panel III to change
the sensor control setting.
3.
Take your finger off the
!
symbol.
Fan run-on time
Switching on
Note:
If intensive mode has been activated, the run-on
function will not be available.
Touch the
A
symbol until
x
lights up on the display
panel.
The fan will run at fan setting 1.
After approximately 10 minutes, the fan will switch itself
off automatically.
Switching off
Slide your finger to the right across control panel III until
a fan setting lights up in the display.
This immediately stops fan run-on.
Saturation display
If the metal grease filters or activated charcoal filter are/
is saturated, the corresponding symbols will flash once
the appliance has been switched off:
■
Metal grease filter:
!
■
Activated charcoal filter:
"
■
Metal grease filter and activated charcoal filter:
!
and
"
If you have not yet done so, the metal grease filters
should now be cleaned or the activated charcoal filter
replaced.
~
"Cleaning and maintenance" on page 13
The saturation indicators can be reset while they are
flashing. Slide your finger to the left across the control
panel to do so.
Switching over the display for air recirculation mode
For air recirculation mode, the electronic controller must
be switched over accordingly:
■
The extractor hood must be connected and switched
off.
■
Touch and hold the
#
and
!
symbols at the
same time until "2" lights up for air recirculation
mode (filters that cannot be regenerated).
■
Repeatedly touching and holding this button
combination makes "3" light up for air recirculation
mode (filters that can be regenerated).
■
Repeatedly pressing and holding this button
combination switches the electronic controller back
over to air extraction mode ("1" ).
Audible signal
Switching on
Touch and hold the
#
and
&
symbols at the same time
for approximately 3 seconds when the fan is switched
off. An audible signal will sound as an
acknowledgement.
When the signal tone is activated,
‚
will be lit.
Switching off
Touch and hold the
#
and
&
symbols at the same time
for approximately 3 seconds when the fan is switched
off. An audible signal will sound as an
acknowledgement.
When the signal tone is deactivated,
‹
will be lit.
Содержание LC91KWW20B
Страница 23: ...6 ...
