en
Installation and connection
8
The supply connection point shall be accessible with
the appliance installed.
WARNING: Ensure that the hose assembly is restrained
from accidental contact with the flue outlet of an
underbench oven.
Before Leaving
Check all connections for gas leaks with soap and
water. DO NOT use a naked flame for detecting leaks.
Ignite all burners both individually and concurrently to
ensure correct operation of gas valves, burners and
ignition. Turn gas taps to low flame position and
observe stability of the flame for each burner
individually and all together. Adhere the duplicate data
plate to an accessible location near the hotplate. When
satisfied with the hotplate, please instruct the user on
the correct method of operation. In case the appliance
fails to operate correctly after all checks have been
carried out, refer to the authorised service provider in
your area.
It should be expressly noted that we cannot accept any
liability for direct or indirect damage caused by wrong
connection, leakage or improper installation. When
being repaired, the appliance must always be
disconnected from the mains supply; if required, notify
our customer service.
Converting the cooktop from Nat. Gas to
Propane
All work involved in installation, setting and adaptation
to a different gas type must be carried out by a licensed
gas fitter and must comply with current regulations and
the conditions laid down by the local gas company.
Before conversion the cooktop must be disconnected
from the electricity and gas valves must be turned to the
OFF position.
Important:
After finishing, stick the sticker, indicating
the new gas type, close to the specifications plate.
Replacing the injectors
Request change-over injectors from our customer
service deparment (refer injector chart below for sizes).
Replacing the nozzles of high-output, standard-
output and economy burners
1.
Remove the pan supports, burner caps and
diffusers.
2.
Change the nozzles using the spanner (code
424699) provided by our Technical Assistance
Service, taking special care to ensure that the nozzle
does not fall when it is removed from or fitted to the
burner.
Ensure that it is completely tightened in order to
guarantee the seal.
Primary air adjustment is not necessary with these
burners.
Replacing the nozzles on dual-flame burners
Before you can replace the nozzles, you will need to
remove the glass plate with the cut-out profiles for the
appliance. The glass plate with the cut-out profiles is
connected to the rest of the hob by means of a clip
system.
Removing the glass plate with the cut-out profiles:
1.
Remove all wire racks, burner caps, burner rings,
control elements and burner cups.
2.
Undo the screws on the burners.
Natural Gas
Propane
Hourly Gas
Consumption
(MJ)
Injector
mark
Hourly Gas
Consumption
(MJ)
Injector
mark
Economy
burner
4,8
97
3,5
53
Standard-
output
burner
8.1
130
6
70
High-output
burner
11.6
157
8.5
83
Wok burner
(inner)
22
65
20
47
Wok burner
(outer)
215
115
Distance Z
11
11
Содержание iQ700 ER9A SD7 Series
Страница 19: ......
