en
Laundry
30
Z
Laundry
Laundry
Preparing laundry for washing
Protecting your laundry and appliance
Caution!
Damage to the appliance/textiles
Foreign objects (e.g. coins, paper clips,
needles, nails) may damage the
washing or components of the
appliance.
The following instructions must be
observed when preparing your laundry:
■
Always follow the manufacturer's
instructions when dosing
all detergents, cleaning aids, care
products and cleaning agents.
■
Do not exceed maximum load.
Overfilling will impair the washing
result.
■
Keep detergents and agents for the
pretreatment of laundry (e.g. stain
remover, prewash sprays, etc.) away
from the surfaces of the appliance.
Using a damp cloth, immediately
remove any fine spray residue and
other residue or droplets.
■
Empty any pockets. Remove any
foreign objects.
■
Remove metal parts (paper clips,
etc.).
■
Trousers, knitwear and knitted
textiles, e.g. jersey garments, T-shirts
or sweatshirts, should be turned
inside out.
■
Ensure that underwired bras are
appliance-washable.
■
Wash delicates in a net or bag
(tights, underwired bras, etc).
■
Close zips, button up covers.
■
Brush sand out of pockets and
collars.
■
Remove curtain fittings or place in a
net/bag.
Note:
The higher spinning speed in the
spinning phase, the higher the noise
and the lower remaining moisture
content
Rinse hold
■
If the spin function was
deactivated at the start of the
wash cycle, the washing
programme is automatically
stopped after the final rinse.
The display panel shows
Âþ¿
alternating with --:--
In order to drain the rinsing
water and, if required, spin the
laundry:
– Press theSpin repeatedly
until the required spin
speed is set. The water is
Drained and the washer-
dryer spins the laundry.
Theprogramme is
completed when
“Ÿš
appears in the display field.
– The maximum spin speed
depends on the selected
wash programme.
If you do not wish to spin the
laundry:
– Press the Spin button
(remaining time for Draining
is displayed). The water is
Drained, but the washer-
dryer does not spin the
laundry. The programme is
complete when
“Ÿš
appears on the display
panel.
– Set the programme selector
to Off
– Remove the laundry.
– Leave the door open to
allow the inside of the
washer-dryer to dry out.
– Turn off the tap (not
necessary on models with
Aqua-Stop).