background image

en

        Getting to know your appliance

6

*

Getting to know your 

appliance

Getting to know your appliance

You can find your appliance and the burner powers in 

the model overview. 

~

 Page 2

Controls and burners

Each control knob is marked with the burner it controls. 

You can use the control knobs to set the output 

required in each case to various positions between the 

maximum and the minimum settings. Never try to switch 

directly from position 0 to position 1 or from position 1 

to position 0.

It is essential to ensure that all the burner parts and pan 

supports are correctly installed for the appliance to 

work correctly. Do not swap the burner caps around.
Always remove the pan supports carefully. When 

moving a pan support, the pan supports next to it may 

also move.

Accessories

Depending on the model, the hob may include the 

following accessories. These can also be acquired from 

the Technical Assistance Service.

--------

Code

The manufacturer accepts no liability if these 

accessories are not used or are used incorrectly.

Indicators

¼

Burner controlled by control knob

Ú

Switched-off burner

9

Highest power setting and electric ignition

1

Lowest power setting

Burner parts

1

Ignition plug

2

Thermocouple

3

Burner cup

4

Burner cap

Additional wok grid

 

Only suitable for use on wok 

burners. Use cookware with a 

rounded base.
To extend the service life of the 

appliance, we recommend using 

the additional wok grid.

Additional espresso maker 

grid

 

Only suitable for use on the 

smallest burner. Use cookware 

with a diameter of less than 

12 cm.

Simmer cap

Only use the cap for cooking 

with minimal power. Place the 

simmer cap on the cover of the 

economy burner. Always place 

cookware on the pan support, 

never directly on the simmer 

cap.

HZ298108 Additional wok grid: Cast iron (mini wok 

burner)

HZ298107 Additional wok grid: Cast iron (4-5 kW)

HZ298110 Additional wok grid: Enamelled steel

HZ298114 Additional espresso maker grid

HZ211310 Simmer cap

Gas burners    

en

7

Ä

Gas burners

Gas burners

Switching on manually

1.

Press the control knob for the selected burner and 

turn it anticlockwise to the highest power setting.

2.

Hold an igniter or a naked flame (such as a lighter or 

a match) against the burner.

Automatic ignition

If the hob has automatic ignition (ignition plugs):

1.

Press the control knob for the selected burner and 

turn it anticlockwise to the highest power level.

While the control knob is held down, all the burners 

will generate sparks. The flame ignites. Wait a few 

seconds.

2.

Release the control knob.

3.

Turn the control knob to the required position.

If the burner does not ignite, switch it off and repeat the 

steps described above. This time, hold the control knob 

down for longer (up to 10 seconds).

:

Warning – Risk of deflagration! 

If the flame does not ignite after 15 seconds, switch off 

the burner and open a window or the door to the room. 

Wait at least one minute before switching the burner on 

again.

Note: 

It is important to keep the appliance clean. If the 

ignition plugs are dirty, this may cause ignition 

problems. Clean the ignition plugs regularly with a 

small, non-metallic brush. Take care to prevent the 

ignition plugs from suffering any heavy knocks.

Safety system

Your hob is equipped with a safety system 

(thermocouple) that cuts off the gas when the burners 

are accidentally switched off.

To ensure that this device is active:

1.

Switch on the burner as usual.

2.

Without releasing the control knob, press and hold it 

down firmly for 4 seconds after lighting the flame.

Switching off a burner

Turn the corresponding control knob clockwise to the 0 

setting.
A few seconds after the burner is switched off, a sound 

(thud) will be produced. This is not a fault - this means 

that the safety device is no longer operating.

Warnings

It is normal to hear a soft whistling noise while the 

burner is operating.
When first used, it is normal for the burner to give off 

odours. This does not pose any risk and does not 

indicate a malfunction. They will disappear in time.

An orange-coloured flame is normal. This is caused by 

the presence of dust in the atmosphere, spilt liquids, 

etc.
In the event of the burner flames being accidentally 

extinguished, turn off the burner control and do not 

attempt to re-ignite the burner for at least one minute.

J

Settings table and tips

Settings table and tips

Suitable pans

The cookware must not overhang the edge of the hob.
You should only use cookware with a domed base if 

your cooktop features a wok burner and the additional 

wok grid. The additional wok grid must be correctly 

positioned.

Precautions for use

The following advice is intended to help you save 

energy and prevent pan damage:

Burner

Minimum diame-

ter of the cook-

ware base

Maximum diame-

ter of the cookware 

base

Wok burner 

22 cm

30 cm

High-output burner

20 cm

26 cm

Standard-output burner

14 cm

22 cm

Economy burner

12 cm

16 cm

Use pans which are the 

right size for each burner.

Do not use small pans on 

large burners. The flame 

must not touch the sides 

of the pan.

Do not use damaged 

pans, which do not sit 

evenly on the hob. Pans 

may tip over.

Only use pans with a 

thick, flat base.

Do not cook without using 

a lid and make sure the lid 

is properly fitted. This 

wastes energy.

Always centre the pan 

over the burner, not to one 

side. Otherwise it could tip 

over.

Do not place large pans 

on the burners near the 

control knobs. These may 

be damaged by the very 

high temperatures.

Содержание IQ500 EP6A Series













Отзывы: