Installing and connecting the device
3.2 Installing the built-in unit
Industrial Flat Panel IFP1500, IFP1900, IFP2200, IFP1900 PRO, IFP2200 PRO, IFP1900 ETH, IFP2200 ETH
Operating Instructions, 07/2016, A5E31298376-AF
43
3.2.3
Fastening the device with mounting clips or mounting brackets
Requirement
●
All packaging components and protective films have been removed from the device.
●
The mounting clips included in the accessory kit are to hand.
Procedure
Note
If the mounting seal is damaged, the degree of protection is not guaranteed.
Proceed as follows:
1.
Working from the front, insert
the device into the mounting
cut-out. Secure the device to
prevent it from falling out.
2.
Insert a mounting clip into the
cutout provided on the device.
Make sure it is in the correct
position; see the section
(Page 41)".
3.
Tighten the threaded pin to
secure the mounting clip.
The maximum torque when
tightening the threaded pins
of the mounting clips is 0.5 Nm.
4.
Repeat steps 2 and 3 for all
mounting clips.
5.
Check the fit of the
mounting seal.
