Siemens HS658GE 7B Series, Инструкция по эксплуатации

Страница: 31 / 64

Appliance door
en
31
Refitting the appliance door
Follow the instructions in the reverse order to refit the
appliance door.
1.
When fitting the appliance door, ensure that both
hinges are inserted straight into the opening (fig.
!
).
Slide the appliance door down as far as it will go.
2.
Open the appliance door fully. Close the two locking
levers (fig.
"
).
3.
Close the cooking compartment door.
Fitting and removing the glass panels
To facilitate cleaning, you can remove the glass panels
from the appliance door. If required, for example if the
appliance is installed higher up, you can remove the
entire door and lay it on a flat surface.
Locking the appliance door
1.
Open the appliance door fully.
2.
Open the two locking levers on the left and right
(fig.
!
).
3.
Close the appliance door as far as it goes (fig.
"
).
Removing panels
1.
Press on the left- and right-hand sides of the cover
(fig.°
!
).
2.
Remove the cover (fig.
"
).
3.
Lift out the inner panel (fig.
#
) and set it down
carefully on a flat surface.
4.
Take off the seal on both sides and remove it
(fig.
$
).
5.
Lift out the intermediate glass panel (fig.
%
) and set
it down carefully on a flat surface.
6.
If necessary, you can remove the condensate trough
for cleaning. To do this, open the appliance door
fully (fig.
&
).
7.
Tilt the condensate trough up and remove it (fig.
'
).
Clean the panels with glass cleaner and a soft cloth.
Wipe the condensate trough with a cloth and some hot
soapy water.
:
Warning
Risk of injury!
■
Scratched glass in the appliance door may develop
into a crack. Do not use a glass scraper, sharp or
abrasive cleaning aids or detergents.
Risk of injury!
2
1
2 1
2 1