Siemens HR676GB.6B, Руководство пользователя и инструкции по установке

Страница: 31 / 44

Troubleshooting
en
31
Fault Cause and troubleshooting
The appliance does
not start and "Cook-
ing compartment too
hot" appears in the
display. The cooking compartment is too hot for the selected dish or type of heating.
▶
Allow the cooking compartment to cool down and start again.
The time is not dis-
played when the ap-
pliance is switched
off. Basic setting has been changed.
▶
Change the basic setting for the time display.
→
"Basic settings", Page 22
Appliance door can-
not be opened. The cleaning function locks the appliance door; lights up in the display.
▶
Allow the appliance to cool down until goes out in the display.
The childproof lock locks the appliance door.
▶
Use the button to deactivate the childproof lock.
→ "Childproof lock", Page 19
You can switch off the lock in the basic settings.
→
"Basic settings", Page 22
HomeConnect is not
working correctly. Different causes are possible.
▶
Go to www.home-connect.com.
The control panel
cannot be opened. The circuit breaker is faulty.
▶
Check the circuit breaker in the fuse box.
There has been a power cut.
▶
Check whether the lighting in your kitchen or other appliances are working.
Malfunction
1.
Call the after-sales service.
→
"Customer Service", Page 33
2.
If there is water in the water tank, empty the water tank:
‒
Open the appliance door.
‒
Grip on the right and left below the control panel.
‒
Slowly pull out the control panel and push it upwards.
Steam escaping from
ventilation slots dur-
ing cooking Escaping steam is not a fault.
No action required.
The appliance re-
quests descaling
without the counter
appearing in ad-
vance. The set water hardness range is too low.
1. Descale the appliance.
→
"Descaling", Page 26
2.
Check the water hardness and set this in the basic settings.
→
"Basic settings", Page 22
The appliance
prompts you to rinse
it. During the descaling, the power supply is interrupted or the appliance is switched off.
▶
Rinse the appliance twice.
→
"Descaling", Page 26
"Fill water tank" ap-
pears in the display
even though the wa-
ter tank has been
filled. The water tank has not clicked into place.
▶
Insert the water tank correctly so that it engages in the holder.
→
"Filling the water tank", Page 15
The water tank has fallen out. Shaking has caused parts to come loose in the water tank.
The water tank is leaking.
▶
Order a new water tank.
Malfunction
▶
Do not use deionised or filtered water.
→
"Before using for the first time", Page 11
The sensor is defective.
▶
Call the after-sales service.
→
"Customer Service", Page 33
Buttons are flashing. Condensation has formed behind the control panel.
No action required. As soon as the condensation has evaporated, the buttons no longer
flash.