Siemens HiPath Series, Руководство пользователя

Страница: 47 / 62

HSAAP_Installing.fm
A31003-W1110-U101-1-7619, February 2007
HiPath Wireless Standalone Access Point V1.0, Getting Started Guide
47
Installing and configuring the Standalone Access Point
Installing a Standalone Access Point
4 Installing and configuring the Standalone Access
Point
Prior to using the Standalone Access Point, it must be properly installed and configured.
4.1 Installing a Standalone Access Point
To install the Standalone Access Point:
1. Unpack the Standalone Access Point from its shipment carton, and check that all parts are
present. For more information, see
HiPath Wireless Standalone Access Point Getting
Started Guide delivered with the device.
2. Mount the wall bracket, using 3 screws, near the LAN Ethernet cable plug on the wall.
Figure 2 Wall bracket and rear view of the Standalone Access Point
3. Press the back of the Standalone Access Point onto the bracket, aligning it with the open
notches in the bracket. Then slide it downward until the security spring clip holds it in place.
To remove the Standalone Access Point, release the spring clip by inserting an Allen key
(or other similar tool) into the small hole at the bottom of the bracket. Then slide the case
up the bracket and lift off the Standalone Access Point.
7
Do not mount the Standalone Access Point within 1 meter of any large metal object
if the Standalone Access Point has an internal or fixed external antenna.
If the Standalone Access Point has an external antenna mounted away from the
access point, do not mount the antenna within 1 meter of any large metal object.