Siemens HB63AA.20B, Инструкция по эксплуатации

Страница: 14 / 28

14
4.
Remove the two clips from the top of the panel (figure D). To
do this, push the clip downwards slightly with your thumb and
pull the tab outwards with your index finger (figure E).
5. Lift the inner panel, push it slightly upwards and then pull it
down and out (figure F).
Clean the panels with glass cleaner and a soft cloth.
Do not use sharp or abrasive materials or a glass scraper. The
glass could be damaged.
Installation
During installation, make sure that the lettering "right above" is
at the top right.
1.
Insert the inner panel diagonally upwards and attach at the
bottom (figure A).
2.
Reinsert the clips on the top left and right (figure B). To do
this, hook the clips into the top of the bracket and press firmly
until they engage (figure C).
3. Put the complete door base back in place (figure D).
4.
First screw in the two screws at the bottom and then the two
screws at the top (figure E).
5.
Attach the oven door.
Do not use the oven again until the panels have been
correctly fitted.
Troubleshooting
Malfunctions often have simple explanations. Refer to the table
before calling the after-sales service as you may be able to
remedy the fault yourself.
Malfunction table
If a dish doesn't turn out as well as you had hoped, refer to the
section
Tested for you in our cooking studio
, where you will
find plenty of cooking tips and tricks.
( '
)
$
& %
( '
Problem Possible cause Remedy/information
The oven does
not work. The circuit
breaker is
defective. Look in the fuse box and
check that the circuit
breaker is in working order.
Power cut Check whether the kitchen
light or other kitchen appli-
ances are working.
0
and three
zeros light up in
the display.
Power cut Reset the clock.
The oven does
not heat up. There is dust on
the contacts. Turn the control knobs back
and forth several times.
The oven door
cannot be
opened. The
H
symbol lights
up in the dis-
play.
The oven door
is locked by
x
self-cleaning.
Wait until the oven has
cooled down and the
H
symbol goes out.
Problem Possible cause Remedy/information