Siemens HB43AB.20B, Инструкция по эксплуатации

Страница: 12 / 28

12
Cleaning self-cleaning surfaces in the cooking compartment
The back panels, ceiling and side panels of the cooking
compartment are coated with self-cleaning enamel. This
coating absorbs and dispels splashes from baking and
roasting while the oven is in operation. The higher the
temperature and the longer the oven is in operation the better
the result will be.
If dirt is still visible after operating the oven several times, clean
the back panel, ceiling and side panels with hot soapy water
and a soft cloth.
Over time, discolourations may occur, which can no longer be
removed. These will not damage the enamel.
Caution!
Damage to surfaces on self-cleaning areas due to applying
oven cleaner.Never clean the self-cleaning surfaces with oven
cleaner.
If oven cleaner accidentally gets onto self-cleaning surfaces,
remove it immediately with a sponge and plenty of water.
Caution!
Damage to surfaces on self-cleaning areas due to the use of
abrasive and acidic cleaning agents and aids.
Do not use cleaning agents containing abrasive substances or
acids.
Do not use abrasive cleaning aids such as steel wool or
scourers.
Cleaning the cooking compartment floor
Use a dish cloth and hot soapy water or a vinegar solution.
If there are heavy deposits of dirt, use a stainless steel scouring
pad or oven cleaner. Only use when the cooking compartment
is cold. Never treat the self-cleaning surfaces with a scouring
pad or oven cleaner.
Detaching and refitting the rails
The rails can be removed for cleaning. The oven must have
cooled down.
Detaching the rails
1.
Lift up the front of the rail
2.
and unhook it (figure A).
3.
Then pull the whole rail forward
4.
and remove it (Fig. B).
Clean the rails with cleaning agent and a sponge. For stubborn
deposits of dirt, use a brush.
Refitting the rails
1.
First insert the rail into the rear socket, press it to the back
slightly (figure A),
2.
and then hook it into the front socket (figure B).
The rails fit both the left and right sides. The kinked section
must always be at the bottom.
Detaching and attaching the oven door
For cleaning purposes and to remove the door panels, you can
detach the oven door.
The oven door hinges each have a locking lever. When the
locking levers are closed (figure A), the oven door is secured in
place. It cannot be detached. When the locking levers are open
in order to detach the oven door (Fig. B), the hinges are locked.
They cannot snap shut.
ã=
Risk of injury!
Whenever the hinges are not locked, they snap shut with great
force. Ensure that the locking levers are always fully closed or,
when detaching the oven door, fully open.
Detaching the door
1.
Open the oven door fully.
2.
Fold up the two locking levers on the left and right (figure A).
3.
Close the oven door as far as the limit stop. With both hands,
grip the door on the left and right-hand sides. Close the door
a little further and pull it out (figure B).
% $
% $
% $
% $