Siemens HB43.B SERIES, Инструкция по эксплуатации

Страница: 10 / 24

10
Changing the basic settings
This oven has different basic settings. The settings can be
adapted to the user's own needs.
No other time function can be programmed.
1.
Press the
0
button for approximately 4 seconds.
The display panel will show the current basic setting for the
time, e.g.
™‚ for the Selection ‚ .
2.
Set the basic setting using the buttons
@
or
A
.
3.
Confirm with the
0
button.
The display panel shows the following basic setting. Using
the button
0
select the levels and using the buttons
@
or
A
make the setting.
4.
Press the 0 button for approximately 4 seconds.
All basic settings have been applied.
The basic settings can be changed again at any time.
Cleaning function
The cleaning function regenerates the self-cleaning surfaces
inside the oven.
The inside rear and side walls and ceiling of some ovens may
be lined with a highly porous ceramic lining. This lining absorbs
splashes produced during baking and roasting, dissolving them
while the oven is on. This cleaning system makes it possible to
regenerate self-cleaning surfaces that can not properly clean
themselves.
Before cleaning
Remove all pans and unsuitable accessories from inside the
oven.
Cleaning the oven's base and enamelled walls
Before programming the clean function, clean the surfaces
inside the oven that are not self-cleaning. Otherwise, stains will
appear that are impossible to remove.
Use a cleaning cloth and hot water with a little soap or vinegar.
If very dirty, use a fine steel scourer or a special oven cleaning
product. These must only be used when the oven interior is
cold. Do not use metal scourers or special oven cleaning
products on self-cleaning surfaces.
Setting
Cleaning takes approximately one hour.
1.
Turn the control knob to Hot Air 2 .
2.
Turn the temperature knob to s .
3.
Press the s button.
The time when the cleaning will be finished is displayed and an
arrow N will appear in front of the y symbol. Self-cleaning
starts within a few seconds. The duration is displayed, and an
arrow N is displayed in front of the x symbol. The y symbol
switches off.
The cleaning has finished
A beep will sound. The oven will stop heating. The display
panel will show
‹‹
:
‹‹
. Press the
0
button twice and turn the
function control knob to position
Û
. The oven switches off.
To cancel cleaning
Press the button s and turn the function control knob to
the Û setting. The oven switches off.
Delaying the end time
The time at which cleaning finishes can be changed. Thus,
for example, the oven can be cleaned at night leaving it free for
use during the day.
Program as described in point 1 to 3. Before cleaning is
finished, delay the end time using the
@
or
A
buttons.
The oven is set to standby. The time when the cleaning will be
finished is displayed and an arrow
N
will appear in front of
the
y
symbol. When cleaning begins, the time is displayed
and an arrow
N
appears in front of the symbol
x
. The
y
symbol switches off.
After cleaning
Once the inside of the oven has cooled, clean the ash remains
from the self-cleaning surfaces using a damp cloth.
Basic settings
Selection
‚
Selection
ƒ
Selection
„
™‚
Time indicator always* only with
the
button
0
-
™ƒ
Duration of signal
after the cooking
time or the time set
on the timer has
elapsed
approx.
10 sec
approx.
2 min.*
approx.
5 min
™„
Time until a set-
ting is applied
approx.
2 sec
approx.
5 sec.*
approx.
10 sec.
* Default setting