Siemens HB43.B SERIES, Инструкция по эксплуатации

Страница: 12 / 24

12
Install the wire shelves or rails
1.
First insert the shelf or the rail in the rear groove by pushing it
back slightly (figure A)
2.
then insert it in the front groove (figure B).
Wire shelves or rails can be adjusted on the left and right hand
side. Their curvature should always be face down.
Unhooking and hanging the oven door
The front panel can be unhooked to help remove the oven door
and clean the glass panels.
The oven door hinges are fitted with a locking lever. The door
cannot be unhooked if the locking lever is closed (figure A).
Once the locking lever has been opened to unhook the door
(figure B), the hinges will be locked in position. This prevents
the door from suddenly closing.
:
Risk of injuries.!
The hinges may close suddenly if they are not locked in
position by the lever. Note that the locking levers are always
closed, apart from when unhooking the door, when the levers
must be open.
Unhooking the door
1.
Fully open the oven door.
2.
Remove both locking levers located on the right and left hand
sides (figure A).
3.
Fully close the oven door as far as possible (figure B). Grip
the left and right hand sides of the door with both hands.
Close the door slightly more and remove it.
Hanging the door
Rehang the door by following the same steps but in reverse
order.
1.
When refitting the door, check that both hinges are
positioned exactly inside their respective openings
(picture A).
2.
The bottom groove of the hinges must fit snugly on both
sides.
The door may be left crooked if the hinges are not mounted
properly.
3.
Reclose the attachment levers (picture C). Close the oven
door.
:
Risk of injuries.!
Do not touch the hinges; the door might accidentally fall or a
hinge might suddenly close. Notify the Technical Assistance
Service.
Removing and installing the door panels
To facilitate cleaning, you can remove the glass panels from the
oven door.
Dismantling
1.
Unhook the oven door and place it on a cloth with its handle
pointing downwards.
2.
Remove the upper cover from the oven door. To do this,
press with your fingers on the tabs on the left and right
(Figure A).
3.
Lift and remove the top glass panel (Figure B).
%
$
% $
% $
% $
&
% $