Siemens Gigaset SL400, Руководство пользователя

Страница: 76 / 97

75
Customer Service & Assistance
Gigaset SL400/400 A / IM-MEA EN / A31008-M2103-A601-1-UZ19 / appendix.fm / 11.05.2010
V
e
rsion 4, 16.0
9
.2005
Gigaset SL400A only:
Authorisation
This device is intended for connection to
analogue networks outside the EEA (with
the exception of Switzerland) depending on
national type approval.
Country-specific requirements have been
taken into consideration.
We, Gigaset Communications GmbH,
declare that this device meets the essential
requirements and other relevant regulations
laid down in Directive 1999/5/CE.
A copy of the 1999/5/EC Declaration of Con-
formity is available at this Internet address:
www.gigaset.com/docs
Handset does not ring.
1. The ringtone is deactivated.
¥
Activate the ringtone (
¢
page 68).
2. Call divert set for "All Calls".
¥
Deactivate call divert (
¢
page 35).
3. The phone only rings if the phone number has
been transferred.
¥
Activate the ringtone for unknown calls
( ¢
page 68).
You cannot hear a ringtone/dialling tone from
the fixed line network.
The phone cord supplied has not been used or
has been replaced by a new cord with the wrong
pin connections.
¥
Please always use the phone cord supplied or
ensure that the pin connections are correct
when purchasing from a retailer (
¢
page 82).
The connection always terminates after approx.
30 seconds.
Repeater activated/deactivated (
¢
page 71).
¥
Activate/deactivate the handset (
¢
page 22).
Error tone sounds after system PIN prompt.
You have entered the wrong system PIN.
¥
Reset the system PIN to 0000 (
¢
page 71).
Forgotten the system PIN.
¥
Reset the system PIN to 0000 (
¢
page 71).
The other party cannot hear you.
You have pressed the mute button
h
.
The handset is "muted".
¥
Reactivate the microphone (
¢
page 30).
The number of the caller is not displayed
despite CLIP.
Calling Line Identification is not enabled.
¥
The caller should ask the network provider to
enable Calling Line Identification (CLI).
You hear an error tone when keying an input.
Action has failed/invalid input.
¥
Repeat the operation.
Watch the display and refer to the user guide if
necessary.
You cannot listen to messages on the network
mailbox.
Your PABX is set for pulse dialling.
¥
Set your PABX to tone dialling.
No time is specified for a message in the call list.
Date and time have not been set.
¥
Set the date/time (
¢
page 16).
The answering machine announces "PIN is
incorrect" during remote operation.
1. You have entered the wrong system PIN.
¥
Enter the system PIN again.
2. The system PIN is still set to 0000.
¥
Set the system PIN to something other
than 0000 ( ¢
page 71).
The answering machine is not recording any
messages/has switched over to answer only.
Its memory is full.
¥
Delete old messages.
¥
Play back new messages and delete.
Exclusion of liability
Some displays may contain pixels (pic-
ture elements), which remain activated
or deactivated. As a pixel is made up of
three sub-pixels (red, green, blue), it is
possible that pixel colours may vary.
This is completely normal and does not
indicate an error.