9
First steps
A58H / USA EN / A31008-M2055-R301-1-6019 / starting.fm / 06.07.2010
V
e
rsion 4, 29.1
0
.2007
The following is displayed after successful automatic or manual handset
registration:
The handset is assigned the lowest unassigned internal number (1–4). If more than
one handset is registered to the base station, the internal handset number appears
on the display, e.g.
INT 2
. If the internal numbers 1–4 are already assigned to other
devices, the number 4 will be overwritten.
To charge the batteries, leave the handset in the base station/charging cradle.
Should you have any questions and problems
Initial charging and discharging of batteries
The correct charge level can only be displayed if the batteries are first fully charged
and
discharged.
Ð
V
Þ
Menu
u
the strength of the reception signal between base
station and handset:
– good to poor:
Ð i Ñ Ò
– no reception:
|
flashes
u
battery charge status:
–
=
e
V
U
(flat to full)
–
=
flashes: batteries almost flat
–
e
V
U
flashes: charging procedure
Please note
Only place the handset in the base station or charging cradle that is intended
for it.
Please note
u
After the first battery charge
and
discharge, you may replace your handset
in its base station or charging cradle after every call.
u
Always repeat the charging and discharging procedure if you remove the
batteries from the handset and reinsert them.
u
The batteries may warm up during charging. This is not dangerous.
u
After a while, the charge capacity of the batteries will decrease for technical
reasons.
¤
Place the handset in the base station or charg-
ing cradle for
eleven
hours.
¤
Then remove the handset
from the base station or
charging cradle, and do not
replace it until the batteries
are completely discharged.
10 h
