Siemens Gigaset A160, Инструкция по эксплуатации

Страница: 21 / 24

9
Athen / en_Master02 / A31008-M1801-T101-2-8U19 / Athen_en_Kombi_neu.fm / 18.10.2008
Appendix
Entering special characters
Standard characters
Greek
Specifications
Recommended battery pack
(Valid at the time of going to press)
Nickel-metal-hydride (NiMH):
Handset A16: V30145-K1310-X383, -X359
Handset A26: V30145-K1310-X359, X402
The handset is supplied with the recommended
battery pack.
Base station power consumption
In standby mode: approx. 2W
During a call: approx. 3W
General specifications
Care
Wipe the base station, charging cradle and
handset with a damp cloth (do not use sol-
vent) or an antistatic cloth.
Never use a dry cloth. This can cause static.
Contact with liquid
If the handset has come into contact with liquid:
1
Switch off the handset and remove the bat-
tery pack immediately .
2 Allow the liquid to drain from the handset.
3 Pat all parts dry, then place the handset with
the battery compartment open and the keypad
facing down in a dry, warm place for at least
72 hours ( not in a microwave, oven etc.).
4 Do not switch on the handset again until it is
completely dry.
When it has fully dried out, you will normally be
able to use it again.
Questions and answers
If you have any queries about the use of
your phone, you can contact us any time at
www.gigaset.com/customercare. The table below
contains a list of common problems and possible
solutions.
1x 2x 3x 4x 5x 6x
1
Space
1 £ $ ¥ ¤
Q
. , ? ! 0 +
P
* / ( ) < =
#
Abc-->
123
123-->
abc
# @ \ &
1x 2x 3x 4x 5x 6x
1
Space
1
£ $
Q
. , ? ! 0 +
P
* / ( ) < =
#
Abc-->
123
123-->
abc
# @ \ &
DECT standard is supported
GAP standard is supported
Range up to 300 m outdoors,
up to 50 m in buildings
Base station power sup-
ply
230 V ~/50 Hz
Environmental conditions
in operation
+5 °C to +45 °C;
20% to 75% humidity
Problem Cause Solution
Nothing
appears in the
display.
The handset is
not switched on.
Battery pack is
flat.
Press the end call key
a
for approx. 5
seconds or place the
handset in the base
station.
Charge/replace the
battery pack (page 3).
No reaction to
keystroke.
The key lock is
activated.
Press the hash key
R
for approx. 2 sec
(page 1).
No wireless
connection to
the base sta-
tion, Base
flashes in the
display.
The handset is
outside the range
of the base sta-
tion.
The handset is
not registered.
The base station
is not switched
on.
Cords not routed
correctly
Move the handset
closer to the base
station.
Register the handset
(page 3).
Check the power con-
nector at the base
station (page 2).
Check cord routing
(page 2).
!