GAMMA wave
Technical Product Information
February 2007
Switch actuator wave GE 561/01
5WG3 561-4AB01
Siemens AG
wave GE 561/01, 6 pages
Technical Manual
Automation and Drives Group
Electrical Installation Technology
©
Siemens AG 2007
Update: http://www.siemens.de/gamma
P.O. Box 10 09 53, D-93009 Regensburg
Subject to change without prior notice
2.20.8.1/3
Connect power supply and load circuit (Diagram C)
- The connections for the power supply and the load
circuits are composed of screw terminals (C1).
- Insulate the conductors to be connected approx.
7 … 8 mm, place in the terminals (C1) and screw in.
- The lead sheath is to be attached with the wire fixing
(C2) to the housing of the installation device.
Note:
Conductors up to 1.5 mm
2
single-wire can be
looped directly to the terminal. It should be noted with
looping that the maximum terminal current of 16 A must
not be exceeded!
With installation it should be noted that the outer conduc-
tor (L) and the neutral conductor (N) must not be trans-
posed, since otherwise the sensitivity of the radio re-
ceiver will be reduced and telegram losses may thereby
occur.
1
2
3
4
5
Kanal 1
L 1
N
L 2
Kanal 2
C1
C2
C3
C4
Diagram C
C1 Screw
terminals
C2 Wire
fixing
C3 Pushbutton
C4 LED
1
2 L1
3 N
4 L2
5
Diagram D
Terminal assignment (Diagram D)
1 ––
►
Load output channel A
2 L1 Power supply (L) for actuator electronics and
channel A
3 N
Power supply (N) for actuator electronics
4 L2
Power supply (L) for channel B
5 ––
►
Load output channel B
Note:
An outer conductor must always be connected to
terminal 2 (L1) even if channel A is not used, since the
actuator electronics are supplied with current via termi-
nals 2 and 3.
A
E1
1
2 L1
3 N
4 L2
5
L1 L2 N
B
E3
E4
E5
E6
E2
Diagram E
Connection example
E1 Switch actuator wave GE 561/01
E2 Actuator
electronics
E3 Switch channel A
E4 Switch channel B
E5 Power supply AC 230V, 50 Hz
E6 Electric loads (e.g., lights)
Location and Function of the Display and Operating
Elements
Diagram C
C3 Pushbutton to switch over to the “special function”
operating mode, to select the commissioning func-
tions and to connect the switch actuator via radio.
C4 LED to display different settings and conditions in
the “special function” operating mode during com-
missioning.
Dimension Diagram
Dimensions in mm
mounting holes 249 - 251
274,5
42
32
