Siemens FLENDER N-EUPEX D, Руководство по эксплуатации

Страница: 13 / 23

13 / 23
BA 3102 en 02/2016
3.3 Axial fastening
Arrange set screw on the parallel keyway. An exception are the following coupling parts:
Part 2: Size 110 : Bore D
1
≥ 30 mm set screw displaced by 180° relative to the keyway.
Part 4: Size 68 : Bore D
1
≥ 20 mm set screw displaced by 180° relative to the keyway.
Part 9: The arrangement of the keyway must be obtained from table 7, depending on dimension "W2".
Position of the set screw to table 8.
Use threaded studs to DIN 916 with cup points as set screws (set­screw size to table 8).
The set screw is intended to fill out the screw thread as much as possible and must not project beyond the
hub.
Alternatively use end plate; as regards recess contact Siemens.
d1
e4 e3
d1
2) 1)
e9
d1
d1
e10
W2 W2
3) 4)
Fig. 5: Position of the set screw
1) Coupling part 2
2) Coupling part 4
3) Coupling part 9, set screw on keyway
4) Coupling part 9, set screw offset approx. 180° relative to the keyway, arranged between the cams.
Table 7: Arrangement of the set screw at coupling part 9
Size W2 Version Size W2 Version Size W2 Version
125
36 ‐ 39 Fig. 3) 180 Fig. 3)
250
55 ‐ 69 Fig. 3)
< 36 Fig. 4)
200
56 Fig. 3) < 55 Fig. 4)
140
36 Fig. 3) < 56 Fig. 4)
280
55 ‐ 60 Fig. 3)
< 36 Fig. 4)
225
55 ‐ 78 Fig. 3) < 55 Fig. 4)
160 Fig. 4) < 55 Fig. 4) 315 Fig. 4)