Maintenance / troubleshooting
Adding or removing radio devices
7
47 | 62
Building Technologies
A6V10227639_k_en_--
Fire Safety
2016-11-28
4. Remove the old radio device from the base or housing.
The internal alarm indicator flashes briefly at 2-second intervals.
5. Remove the battery pack from the radio device.
6. Store, transport, and dispose of the battery pack in accordance with local
regulations and laws. See also chapter 'Basic principles for replacing the
The radio gateway registers the old radio device as missing after a
maximum of 5 minutes.
LED (H4) flashes.
7. Remove the adhesive label from the radio device and use it to mark the
installation location on the device location plan.
8. Connect the power supply for the radio device.
The internal alarm indicator of the radio device flashes.
If it flashes red, this indicates the factory settings.
If it flashes green, this indicates that the radio device has already been
logged on to a radio gateway and needs to be set to the factory settings.
9. To set a radio device to the factory settings, press the 'new' button on the radio
device until the internal alarm indicator flashes red.
The radio device is set to the factory settings.
10. Install the radio device in the appropriate base (FDOOT271) or the appropriate
housing (FDM273).
The search for the radio network starts. During the search, the internal
alarm indicator briefly flashes green twice, at an interval of 2 seconds.
Once the radio device has successfully been logged on to the radio
gateway, the network search stops and the internal alarm indicator goes
out.
11. If the logon process has not been successful after a long period of time has
passed, briefly remove the radio device from the base/housing and then re-
insert it.
The search for the radio network starts again.
12. Finish the process of logging the radio devices on to the radio gateway.
– Check that the process of logging on to the radio gateway is complete.
– Wait until the LED (H4) on the radio gateway goes out.
13. Press and hold button (S1) for at least 2 seconds.
The radio cell is in normal operation.
The radio gateway deletes the old radio device from its memory.
14. Close the radio gateway housing.
15. Switch the detector line on at the station and read in the new radio device in
accordance with the documents for the fire control panel.
16. Make a note of the change in your documents.
The radio device has now been replaced.
See also
