Siemens Desigo PXC4.E16, Руководство пользователя

Страница: 5 / 16

5
Siemens Schweiz AG A6V11646018_en--_e
Smart Infrastructure 2021-06-11
LED displays
Activity LED Color Activity Function
Ethernet 1/2 Green Continuously ON
Continuously OFF
Flashing Link active
No connection
Network traffic
Yellow Continuously ON
Continuously OFF Link 100
Link 10 Mbps
RUN Green Continuously ON
Continuously OFF
Flashing Device operational
Device not operational
Start-up or program halted
Red Continuously OFF
Continuously ON
Rapid flashing OK
HW or SW fault
Firmware or application missing/corrupted
Blue Continuously ON
Continuously OFF Connection to the cloud OK
No connection to the cloud
COM TX
(PXC4.E16)
Yellow Flashing
Continuously OFF Communication
No communication to subsystem
COM RX
(PXC4.E16)
Yellow
SVC Red Continuously OFF
Flashing OK
Device is not configured
Flashing per wink
command Identification of the device after receipt of
wink command
2s
1s
5 Hz 5 Hz
2s
1s
WLAN Blue Steady OFF
Steady ON
Flashing
WLAN inactive
WLAN active and at least one WLAN client
connected
WLAN active and no WLAN client
connected
Service button Short press (< 1 s)
Long press (> 3 s)
Identification in the network
Enable / disable WLAN
WLAN is disabled automatically after 10
min if no client is connected
As per description Do the following to reset the device to
factory state:
1. Power off the device.
2. Power on the device.
3. Wait until all LEDs light up and
turn off again, then press the
Service button.
4. Keep the Service button
pressed until all LEDs light up,
then release the button.
All LEDs go off, the device re-
starts.
5. Wait until the device has fully
started – unconfigured (green
RUN LED and red SVC LED
are flashing)