7
Smart Infrastructure
A6V13605540_en--_b
Smart Infrastructure
2022-10-14
Technical data
Power supply (not provided)
Input
AC 85-264 V
Output
DC 24 V ±10 %, min. 2 A
Cable between power supply and Connect Box
2 wires (red, black)
22 AWG , minimum section: 0.35 mm
2
Internal protection
Protection against overvoltage, undervoltage, and
overcurrent from the power supply with indication by
LED: green LED when the power supply is compatible,
red LED if it is not suitable.
Function data
Hardware information
Processor
ARM Cortex A7, 528 MHz
Operating system
Linux
Storage
512 MB RAM
4 GB Flash
Interfaces
Ethernet interface
Plug
2 x RJ45, shielded
Interface type
10Base-T / 100Base-TX, IEEE 802.3 compatible
Bit rate
10/100 Mbps, autosensing
Protocol
BACnet/IP on UDP/IP, BACnet/SC on TCP/IP, and
HTTPS on TCP/IP
Cabling (in-house cabling only), cable type
10 Mbps: Min. CAT3, shielded cable is recommended
100 Mbps: Min. CAT5, shielded cable is recommended
Cable length
Max. 100 m (330 ft)
Modbus RTU interface
Interface type
EIA-485, not isolated
Baud rate
300, 600, 1200, 2400, 4800, 9600, 19200, 38400,
57600, 76800, 115200 (depending on the configuration)
Bus termination
120 Ohm to be added on connector by the integrator on
the bus (both ends of the bus)
Internal bus polarization
No
Cabling (in-house cabling only)
Cable length
3-wire cable, shielded cable recommended (shield must
be connected to building earth in the mounting panel)
Protection
Short-circuit protection with resettable fuse
-7 V to +12 V common-mode
Up to 15 V overvoltage protection