Installation instructions
en
19
4.
Unscrew the two lower screws on the back of the
appliance.
5.
Use the two screws to tighten the two metal retain-
ers on the back of the appliance.
‒
Ensure that the metal retainers are aligned ex-
actly with the edge of the appliance.
6.
Slide the appliance into the fitted unit and check
whether the tilt protection engages.
7.
If required, correct the position of the bracket with
the elongated hole.
8.
Screw the brackets to the fitted unit.
9.
Remove the adhesive strip from the appliance front.
10.
Open the appliance carefully and check whether the
tilt protection is working.
Adjusting the appliance front
Adjust the appliance front upwards or downwards if ne-
cessary.
1.
Open the appliance.
2.
Undo the screws on the side of the panel.
3.
Align the appliance front upwards or downwards.
Alignments of maximum -3 to +3 mm are possible.
4.
Tighten the screws.
