Siemens AZL66 Series, Руководство пользователя

Страница: 4 / 14

4/14
Smart Infrastructure CC1N7562en
12/20/2019
Mounting notes

Ensure that the relevant national safety regulations and notes on standards are
complied with

Please note that the mounting surface must be completely flat

The AZL66 must be used in a dry and clean environment

Note the tightening torque of 0.5 Nm; this is a condition for compliance with IP54
Step 1 Position the AZL66 in the correct place
inside the designated opening (do not
apply excess pressure).
Step 2 Next, screw the AZL66 tight with the
countersunk cross-head screws in the
housing (do not apply excess pressure).

Note!
If the AZL66 does not fit inside the
designated opening, check the cut-out
and the housing.
The AZL66 units are manufactured with installation dimensions of 90.1 x 125.7 mm

0.5. The dimensions of the front panel result in a grid dimension of 90.5 mm. The
mounting mechanisms enable the ALZ66 units to be installed in front panels of various
thicknesses (1–3 mm).

Please note that the mounting surface must be completely flat

The M4 screws with O-rings (such as those similar to 10-UNF) are equipped with a
swivel bolt lock and are included in the scope of delivery of the AZL66
Panel cut-out mounting of the
AZL66
Cut-out dimensions
for the AZL66